二级工程师

Able to perform the following activities:

• Review of Tender document, technical specifications and preparation of Design Intent Document

• Preparation of Protection SLD showing principles, relays and meters

• Preparation of Functional Design Standards/Descriptions

• Preparation of Signal list, trip matrix, Logics & Interlocks

• Review of Vendor drawings and documents (technical vetting of Control & Relay panels, Auxiliary System)

• Preparation of schematic diagrams for the interface's equipment in Control & Relay Panel scheme thus providing completeness

• Preparation of relay ordering information.

• Preparation of circuit diagrams - New & Existing Set-up (applicable for retrofit projects)

• Preparation of Cable block diagram

• Preparation of Cable Schedule & BoQ estimation for ordering

• Preparation of Wiring/Termination diagrams

• Preparation of Core sheets

• Preparation of SCS IO Schedule

• Panel Engineering Expertise (Layouts, circuit diagram, wiring table, terminal table etc.,) - Preferred

• Preparation of Voltage drop calculation - Trip & Close coil, LVAC power cable

• Identification of existing drawings and modifying them using Red and Green markups as per standard requirements

• Interface knowledge with Primary Equipment, Bay Controller Units /SCADA/RTU/Tele protection are essential

• Auxiliary Power System design like Low Voltage AC Panel & DC Panel requirements, Aux Tr and Battery & Charger Sizing, ACDC Cable sizing & CB selectivity study.

• CT / VT Sizing

• Relay configuration (Preferred)

• Excellent knowledge in AIS & GIS secondary designs.

• As Built documentation

• Co-ordination with other departments like primary, lead engineer, sourcing, C&R factory counterpart & own department control and protection etc. for design progress & completion

• Vendor Offer Evaluations. FAT / SAT of primary secondary equipment, system as and when needed.

• Ensure Ontime delivery of design deliverables & to be vigilant on project schedule impacts.

• Responsible for obtaining customer approvals for the designs and drawings

• Technical risk and opportunity assessment and validation

• Take part in customer meetings / site visits for tender/project clarifications

• Support and act as interface engineer during erection & commissioning

• Estimation of engineering effort for each project for costing at tender stage

• Innovative ideas to reduce Engineering effort

• Plan, implement, review and continuously improvise quality system

• Ensure the Safety through design principles which meant for complete project lifecycle.

Having an idea about the following activities:

• Vendor Offer Evaluations. FAT / SAT of primary secondary equipment, system as and when needed.
• Ensure Ontime delivery of design deliverables & to be vigilant on project schedule impacts.
• Technical data sheets verification of equipment's. Knowledge of equipment, such as circuit breakers, disconnectors, earthing switches, instrument transformers, power transformers, etc
• Technical risk and opportunity assessment and validation
• Take part in customer meetings / site visits for tender/project clarifications
• Support and act as interface engineer during erection & commissioning
• Estimation of engineering effort for each project for costing at tender stage
• Innovative ideas to reduce Engineering effort
• Vendor Offer Evaluations. FAT / SAT of primary secondary equipment, system as and when needed.
• Ensure Ontime delivery of design deliverables & to be vigilant on project schedule impacts.
• Support and act as interface engineer during erection & commissioning
• Plan, implement, review and continuously improvise quality system & follow OPEX initiatives